Hi folks! I hope you’re all doing great. Before I show you all of the progress on Odrajux, I’d like to take a moment to thank to all of you who follow me for linking and sharing the love. I’ve noticed an exponential boom in followers in these last two weeks and it’s both humbling and overwhelming to see that so many people are interested in what I do. So thank you all so much from the bottom of my scaly heart!
Anyway! These last couple of days I’ve pretty much left Odrajux ready for his paintjob.The first thing I did was his ear membranes. I had already glued the supports, so all there was left to do was cut some fabric to size and fix it in place. I cut big pieces, dipped them in PVA glue and placed them roughly where they should be. I marked the areas where the supports were, and cut the fabric while lying flat on the table. Sometimes cutting sharp angles with proper scissors it’s just impossible when you’re limited by hard edges like in this case. This made the cutting a lot easier! Once the ears were done, I covered some other areas with cloth, and proceeded to grab the clay.
So now that the cloth was done, the fun part began! The clay I used for this was some old-school white Das. This was the first clay I ever used, about two decades ago, so it’s the kind of clay I’m most comfortable with. The good thing is that it’s air-dry, so you don’t have to bake it or anything. The cons are that even though it doesn’t shrink much, it does tend to crack. And also it can dry up quite quickly if you’re not careful (especially where it’s thinnest). I avoid that by spraying water every now and then on it, and you can refill the cracks later.
I started working from the mouth towards the shield, so the first thing I did was the chin. I wrapped the clay around the aluminium structure and shaped it. I did the same for the lower lip, but I added little holes and small nostrils. Also, I modified the length of the lips by adding “lip fangs”: small triangular bits that you’ll recognise to be very dragon-like as soon as you see them. I protected the teeth with some acetate and cling film to avoid messing them up… and then I did the rest of the face (jaws, cheeks and brows). Scroll down to see the results.
Now, the cheekbones turned out to be a bit smaller than I anticipated. I had planned on adding loads of small Fimo horns, but the area was too small and I decided to make thorny scales with Das instead. I put some in the jaws and around the eyes, and added spikes of different sizes all along the top: from the nose to the shield, and left it to dry overnight. Luckily, the Scottish damp and cold climate made it dry quite slowly, so the cracks were few and minimal and it took literally two minutes to fix. The final touch was adding a bit of paper mache to simulate eyebrow wrinkles and also to make the nostrils a bit larger. I think he looks a bit more menacing that way! What do you think?